Page 899 - 2006 HARLEY FLSTCI SERVICE MANUAL

Front camshaft

Rear camshaft Pin stamped timing lines Figure 3-151. Verify Alignment of Timing Lines

d0142b3x

camshaft to ensure that assembly remains square and
outboard ends of the shafts have a second set of timing
camshafts are pressed into the bearings, note that the
the secondary sprockets cannot be observed once the
See Figure 3-151. Since the pin stamped timing lines on
lines. Using a straightedge, verify that these timing lines
are in alignment. If they are not, then the camshafts must
When inner race on rear cam is started into roller bear-
seated. If necessary, keep finger pressure at top of rear
ing, apply pressure to driver until front camshaft is fully
inner race moves to installed position in roller bearing.
be removed and reinstalled (with a new bearing set).

1WARNING 1WARNING Wear safety glasses or goggles when removing or install- ing retaining rings. Retaining rings can slip from the pli- ers and could be propelled with enough force to cause With the sharp edge out, install new retaining ring in

serious eye injury. (00312a) groove at end of front camshaft. 2006 Softail: Engine

HOME 16. 17. 18. 3-112