Page 903 - 2006 HARLEY FLSTCI SERVICE MANUAL

d0214x3x d0215x3x

Hex nut

Figure 3-157. Turn Hex Nut Clockwise to Remove Bearing Figure 3-158. Installer Forcing Screw Installation

Holding flat on collet, turn hex at end of shaft in a coun-
terclockwise direction to close collet. Remove and dis-
Remove hex nut, flat washer and Nice bearing from
Remove four thumb screws and pull support plate from
turn hex nut in a clockwise direction until bearing is free.
See Figure 3-157. Using a 15/16 in. open end wrench,
threaded end of collet. Pull collet from support plate.
Return to step 1 to remove second needle bearing.
If necessary, hold flat on collet to prevent rotation.
SPECIALTY TOOL Camshaft needle bearing remover/installer Obtain the CAMSHAFT NEEDLE BEARING RE- MOVER/INSTALLER (Part No. HD-42325). See Figure 3-156. Sparingly apply graphite lubricant (9) to threads of installer forcing screw (4) to prolong service Thread installer forcing screw into stamped side of sup- port plate (2) until threads begin to emerge from opposite Place installer (6) at end of installer forcing screw. Place new needle bearing on installer with lettered side See Figure 3-158. Aligning two large holes in support plate with needle bearing bores, hang right side of plate Align four holes at corners

crankcase. card needle bearing. Installation PART NO. life and ensure smooth operation. side. facing shoulder. on ring dowel in crankcase flange. 2006 Softail: Engine

HOME 11. 12. 13. 14. 15. HD-42325 1. 2. 3. 4. 5. 6. 7. 3-116