Page 917 - 2006 HARLEY FLSTCI SERVICE MANUAL

3.30

4

1 3
3 Figure 3-181. Removing Bearing From Housing Figure 3-182. Installing Bearing In Housing See Figure 3-182. Place housing (5) with top surface Install a new retaining ring (3) around bearing (4). Set bearing/retaining ring on housing with letters on Center pilot under ram (1) of press. Slowly lower ram to seat bearing until retaining ring fits flush against housing.

1 bearing facing up. Place pilot (2) over bearing.
2 2 upright on a suitable support.
4
5 Retaining ring
Ram Housing Pilot Support Ram Pilot Bearing Housing INSTALLATION
Y
7467 1. 2. 3. 4. 7468 1. 2. 3. 4. 5. 1. 2. 3. 4.
COUNTERBALANCER ASSEMBL

TOP END OVERHAUL: 3.18 BOTTOM END OVER- Wear SPECIALTY TOOL Crankcase bearing remover Balance shaft inner/outer bearing

REMOVAL OVERVIEW 3.16 Perform all steps under DISASSEMBLY. Perform all steps under HAUL: DISASSEMBLY. CLEANING, INSPECTION AND Clean all parts but bearings in a non-volatile cleaning solution or solvent. 1WARNING 1WARNING Compressed air can pierce the skin and flying debris from compressed air could cause serious eye injury. safety glasses when working with compressed air. Never use your hand to check for air leaks or to determine air Blow parts dry with low pressure compressed air. Balance Shaft Support Bearings remover/installer NOTE See LEFT CRANKCASE HALF under 3.29 CRANKCASE to service bearings in left crankcase half. Inspec

HOME 1. 2. REPAIR General 1. flow rates. (00061a) 2. PART NO. HD-44065 HD-44066 REMOVAL 1. 2. 3. 4. 5. 3-130