Page 913 - 2006 HARLEY FLSTCI SERVICE MANUAL

Sleeve
2 Inner Race Thrust Washer
6
3
1 5. 6. 7. Figure 3-174. Press Inner Race Onto Sprocket Shaft Figure 3-175. Press Inner Race Onto Sprocket Shaft

Pilot Shaft Handle
4
5 Flat Washer Nice Bearing
7
f2152x3x 1. 2. 3. 4. f2153x3x

Place new bearing inner race on bench top. Using the
Robinair Heat Gun (HD-25070), uniformly heat bearing
Place new thrust washer over sprocket shaft with the ink
stamp facing outside (and the chamfer on the ID
Wearing suitable gloves to protect hands from burns,
inner race for about 60 seconds using a circular motion.
place heated bearing inner race over sprocket shaft.

1WARNING 1WARNING Obtain the SPROCKET SHAFT BEARING CONE INSTALLER (HD-97225-55B). See Figure 3-173. Assem- Thread pilot onto sprocket shaft until contact is Sparingly apply graphite lubricant to threads of pilot shaft to prolong service life and ensure smooth Slide sleeve over pilot until it contacts bearing inner Slide Nice bearing and large flat washer over pilot Thread handle onto pilot shaft. See Figure 3-174. Rotate handle of tool in a clockwise direction until bear- ing inner race bottoms against thrust washer. See Figure Remove handle, flat washer, Nice bearing, sleeve and

NOTE To facilitate installation without heat, apply a light penetrating oil to shaft and leading edge of bearing inner race. Do not use heating devices with penetrating oil. Penetrat- ing oil is flammable which could result in death or seri- ble tool as described below. made with shoulder. until contact is made with sleeve. 2006 Softail: Engine

HOME Installation 1. inboard). 2. 3. ous injury. (00375a) 4. a. b. operation. c. race. d. e. 5. 3-175. 6. pilot from sprocket shaft. 3-126