Page 911 - 2006 HARLEY FLSTCI SERVICE MANUAL

f2154x3x

Hardened plug Sprocket shaft
3
5 Wedge attachment Bearing inner race
4
2

2 Figure 3-171. Flywheel Fixture (Part No. HD-44358) 4. 5. 6. 7. Figure 3-172. Remove Inner Race From Sprocket Shaft

Hold-down clamp 1 Forcing screw 3/8-16 inch bolt with flat washer

1 Locating pin 7 6 Bridge

f1869x3x 1. 2. PULLER/ 1. 2. 3.

side of right flywheel half, and then hand tighten
Slide hold-down clamp down slot to engage inboard
For proper clamping force, hold-down WEDGE ATTACHMENT (HD-95637-46A) RACE INNER
secure hold-down clamp on opposite side of fly-
knurled nut at bottom to secure. Repeat step to
44358). See Figure 3-171. Install brass jaws or shop
towels around teeth of vise to prevent damage to
If reusing flywheel, remove bearing inner race and thrust
Obtain FLYWHEEL SUPPORT FIXTURE (HD-
assembly on fixture. Slide knurled locating pin down
slot in tool to engage crank pin hole. Hand tighten
Insert crankshaft end through hole resting flywheel
tool. Clamp tool in vise with the round hole topside.
Sprocket Shaft Bearing Inner Race
NOTE clamp must not be tilted. Rotate hex on outboard stud until on inboard side of thrust washer and turn hex nuts an equal number of turns to draw halves of wedge CAUTION Install wedge attachment only so far as necessary to ensure positive contact with thrust washer. Installing tool with more contact than absolutely necessary will Obtain two 3/8-16 inch bolts 6-1/2 inches long (with flat washers). Install flat washers on bolts. Obtain bridge, forcing screw and hardened plug from MAIN- BEARING INSTALLER (HD-34902B). Slide one bolt into channel on each side of bridge so that flat washer is between bridge

washer as follows: locating pin. wheel. Figure 3-171. Position together. result in damage to flywheel. SHAFT ber of turns. bridge. 2006 Softail: Engine

HOME Removal 1. a. b. c. See clamp is level. d. e. f. g. 3-124