Page 327 - Installation Training Binder FIT1-3

Steel : (Option 1c)

Steel base/floor plates should be abrasive blasted to a near white metal
finish, SSPC-10 or NACE-2.

SSPC-SP10 or NACE-2 – Near-White Blast Cleaning

A Near-White Blast Cleaned surface, when viewed without magnification,
shall be free of all visible oil, grease, dirt, dust, mill scale, rust, paint, oxides,
corrosion products, and other foreign matter, except for staining. Staining
shall be limited to no more than five percent of each square-inch of surface
area and may consist of light shadows, slight streaks, or minor discoloration
caused by stains of rust, stains of mill scale, or stains of previously applied
paint. Before blast cleaning, visible deposits of oil or grease shall be removed
by any of the methods specified in SSPC-SP1 or other agreed upon methods.
For complete instructions, refer to Joint Surface Preparation Standard SSPC-
SP10/NACE No. 2

Concrete Restoration

When concrete has deteriorated to the point that the large aggregate is
showing, the area may require restoration prior to coating application,
contact Eviroguard for resurfacing service in your area.

Treatment of Joints, Terminations and Penetrations

When treatment of joints, terminations and penetrations is required,
consult EnviroGuard Technical Service Department.

EnviroGuard 800-206-9884 Fax 909-624-1772 www.enviroguard.com
11/2007 rev. B Condor System Setup Instructions Page - 7 -