Page 328 - Installation Training Binder FIT1-3

Level 1 “New Installations”

A “new installation” is defined by EnviroGuard as a spill containment installation
where the battery rack has not yet been installed.

Step 2

Verify Measurements

Prior to starting the job, review the CAD drawing and compare it with the
actual kit. Verify measurements of the battery rack being used. If a
problem exists, contact the necessary management. (This procedure
should have taken place during the initial job walk; obstacles should have
been identified at that time)

Floor Preparation (See ASTM Floor Prep)

Clean floor thoroughly of any debris that may interfere with a tight seal
between the floor and the spill containment barrier. Snap a chalk line
according to spill containment outside dimensions to identify exact
location. Review Pages 4-8 for More Detailed Floor Preparation
Instructions (Figure 1)

Figure 1

EnviroGuard 800-206-9884 Fax 909-624-1772 www.enviroguard.com
11/2007 rev. B Condor System Setup Instructions Page - 8 -