Page 384 - (KU)01-75GAJ-1.5 - Change 1

INTRO

EP'S (KU)01-75GAJ-1.5 FIGURES

1.10.13 RVSM System Failures
ACAWS
If RVSM required equipment fails during operations in RVSM airspace,
use all available resources to maintain and monitor assigned RVSM
ÀLJKW OHYHO 1RWLI\ $7& LPPHGLDWHO\ RI 5960 HTXLSPHQW IDLOXUH %H GROUND
prepared to exit RVSM airspace. Descent below RVSM airspace may
UHTXLUH D FKDQJH RI SODQQHG ÀLJKW URXWLQJ DQG SRVVLEOH GLYHUVLRQ
&RQWLQXHG ÀLJKW LQ 5960 DLUVSDFH IROORZLQJ WKH IDLOXUH RI 5960 TAKEOFF
required equipment, is possible only with ATC approval.

(End of Procedure) FIRE/SMK
NORM 1.10.13.1 CADC Failure

PRES/OXY
NOT FOR FLIGHT
A failed CADC cannot be used to accurately determine RVSM altitude.
Both pilot and copilot should select the same, fully functional CADC
as their altitude source. A degraded CADC (failed SPTU), while less ENG/PROP
DFFXUDWH FDQ VWLOO EH XVHG WR PRQLWRU 5960 ÀLJKW OHYHO 7KH GHJUDGHG
CADC should be selected as data source by the copilot.

See Crew Action for the following ACAWS messages: FUEL
‡ ADC 1 (or 2) ALTITUDE FAIL
AAR
‡ ADC 1 (or 2) FAIL

SPEC ‡ ADC 1 (or 2) DEGRADED ELEC
(End of Procedure)

1.10.13.2 Failure of Altitude Control HYD

NOTE
FLT CTRL
The standby altimeter is not RVSM compliant and cannot
be used to determine RVSM altitude.

In the unlikely event that both the pilot and copilot autopilot systems GEAR
DUH XQDEOH WR PDLQWDLQ DOWLWXGH ZLWKLQ “ IHHW RI DVVLJQHG ÀLJKW OHYHO
VWHDG\ OHYHO ÀLJKW LQ QRQ WXUEXOHQW FRQGLWLRQV LQ 5960 DLUVSDFH
proceed as follows: DOR/RMP
PERF ‡ 8VH DOO DYDLODEOH UHVRXUFHV WR PDLQWDLQ DVVLJQHG 5960 ÀLJKW

level. JETTISON

‡ Notify ATC and comply with instructions.
LANDING

DITCHING

BAILOUT

OPER FAULT LG

1 -344 Use, copying and/or disclosure is
governed by the statement on the
BACK title page of this document. CHARTS