Page 10 - ALL TASK SOLUTIONS - Our Brand Product Guide 2019

Water Elimination
VB35 eliminates water from the whole petrol, diesel and lpg injection system
by micronising the drops and covering them with EP lubricants.
The fuel pump and injectors are then “EP protected” and the humidity/moisture
is then eliminated during the combustion process.
Anti Freeze Protection

Thanks to the elimination of the moisture and the contribution of some of the
VB35’s components, the flock /freeze point of the diesel fuel is lowered by 5ºC.
VB35 also improves the cold start of lpg engines.
Lubrication Cleaning - Oil Flush

At each service add contents of one VB35 to 4-6 litres of the old oil in the engine.
In case of any doubt or in the case of notable deposits of black
sludge if may be necessary to double or treble the dose of VB35.
Run the engine for approx 10 minutes but the longer the better and for extreme
cleaning run for half an hour.
In order to clean the hydraulic valve lifters raise the rpm above 1000 for short
periods during this time. Drain and replace oil and the filter

Cleaning Gearbox ABS & Power Steering

Add the contents of one VB35 can to 4-6 litres to the OLD oil in the system .
Drive vehicle for 10 mins. Later drain and replace the oil and any filter.
Cleaning Transmission

Add half a can of VB35 to the OLD oil.
Drive the vehicle for 10 mins using all of the gears.
Drain and replace the oil and filter.
The traces of VB35 remaining will be compatable for the seals in the system.
VB35 does not effect oil viscosity, the system is effected by 1% in total after treatment.
VB35 saves time and money doing away with expensive cleaning machines.
Cleaning Cooling System

VB35 Flushes oil and grease from the cooling system.
After the repair, fill the cooling system with clean water and run the engine up
to operating temperature.
Add the contents of one can of VB35 to the water.
Run theengine on high revs for a MAXIMUM of 10 minutes.
Drain and flush with clean water. Repeat if necessary.
Cleaning FAP/ DPF Filter & Cat Converter

Removes soot from the blocked FAP/DPF filters and catalytic converters.
Remove the filter. Tap the bottom.
Pour half a can of VB35 into a 2 litre bottle and then top up with water,
shake and pour mixture into the filter.
Shake the filter and allow the VB35 at least 30 minutes (the longer thebetter)
to soften and dissolve the deposits.
Shake and empty the filter into the waste oil container.
Prepare another mixture and repeat the procedure filling the filter from the
opposite end. Wait at least four hours.
Rinse out the remaining deposits from the filter with clean water.
Cleaning Air Conditioner
VB35 easily dissolves oil and moisture deposits.
Inject 50 - 100ml of VB35into the low pressure gas circuit of the air conditioner
and run the system at maximum Cold for 10 minutes.
Remove the refrigerant gas and dry the circuit with compressed air.
Other Uses

VB35 can also be used to remove asphalt from the paintwork of the vehicle but
only if it has a clear coat. Please contact us for more uses.