Page 133 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

Bug Spray Applicator

Note: The E-1063 programming procedure can be found at the end of this section as opposed to the
FressStyler® Programming Manual.

Overview
The new Bug Spray Applicator was designed for the FreeStyler product line. When a vehicle
enters the wash and stops, the Bug Spray Applicator will spray an even coat of chemical on the
front of the vehicle and windshield. The amount of chemical and length of application time is
user selectable. This can be applied to any or all packages. The bug spray is programmed as
one of the three entrance operations in the E-1063. See that section in the Programming Manual
for details.
The wall mounted chemical pump is the same as the ones for soap, wax and triple foam used
on the FreeStyler. Supply water is connected to the ball valve assembly and the chemical pump
connected to the injector. The discharge line from the ball valve then has a mix of water and bug
spray chemical and is connected with a 3/4” water hose to the cross-over tube.

Utility Requirements

3/4” water supply 8GPM at 40 PSI
120V control for valve and pump Bug Spray chemical
The Bug Spray Applicator requires the use of the following components (included):

Pulsatron™ Pump Assembly Asco™ Valve Assembly

Bug Spray Applicator Nipple Assembly Bug Spray Applicator Manifold Assembly

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 9-1