Page 165 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

Wheel Cleaning and CTA Options

Wheel Stingers and Freestanding CTA

1) Locate the two applicators as shown below.

Primary Secondary
Applicator Applicator

2) The Primary Applicator has the tees mounted into the back and should be positioned on
the equipment room side. The Secondary Applicator will be mounted on the opposite side
of the bay. From the center-line of the equipment the applicators should be mounted 61-
1/4” to the back of the base plate. This should set the nozzles around 112-1/2” apart.
Primary Secondary

Applicator 112-1/2” Applicator
Center-Line
61-1/4” 61-1/4”

Note: Note: In a drive-through configuration the applicators should not be mounted in the path
of the vehicles.

Installation of Bell-Hose

1) Locate the components for the Bell-Hose assembly as shown below.

Rubber Bell Hose
108264 (2): 1CLAMP373
Floor Mounts
Plastic Floor Mat

108264 1CLAMP373

The plastic floor mat will slow down the wear of the hose against the cement floor as
vehicles roll over it.

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 9-33