Page 58 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 4 Frame and Carriage Assembly

Determining Driver Side / Passenger Side Equipment Room

The FressStyler® is shipped with the machine wired and plumbed for a driver side equipment
room/boom location. If your site has a passenger side equipment room/boom location then the
utilities will need to be flipped to the other side of the FressStyler® carriage. You will also need to turn
the hydraulic fittings on the HydroBlade® center feed manifold and the Wheel Cleaner center feed
manifold so that they will face towards driver side.
Unless stated otherwise, all instructions and images are written to reflect a driver side Equipment
Room.
Each time there is a decision to be made on the Equipment Room location, the following symbol will
appear:

Boom Install Oreintation

If your machine has a driver side equipment room then move on to “Installing the Boom Mount”.
If the machine has a passenger side equipment room then follow the steps below to flip the machine to a passenger side
configuration.

On the machine there is a Bulkhead Mount Block (shown below) located on the center/exit side of the carriage. For all
of the utility lines that are plumbed in to this, it will be necessary to unhook them from the Bulkhead and run all lines to
the opposite side of the Bulkhead Mount Block. This should be done one line at a time to ensure that the lines are
hooked back up properly. It will also be necessary to re-loop the lines inside the utility covers to achieve a proper bend
in the line. Do this for all of the poly-flow lines as well as the blue water hose lines. Be sure all lines are pressed in tight
and all clamps are clamped tight.

4-16 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220