Page 14 - Multi-Purpose Arch

MULTI-PURPOSE ARCH

Installation

Locating the Correct Parts
Both leg assemblies are identical and can be used on either side. There are two decals, one to be
displayed on each side of the Pendant. When erecting your MULTI-PURPOSE ARCH notice the off-
set holes on the top of the Pendant and stand the Arch up accordingly.
Use stainless-steel compatible Teflon™ tape and Liquid Teflon™ on ALL fittings.
When positioned properly the nozzles on the entrance and exit side should all point outward (away from the Arch).
1) Uncrate and inspect shipment for damage, and to verify that all pieces are there. If there is any
damaged equipment, file a claim with the trucking company immediately. Receiving party is responsible
for filing claim with trucking company. Notify your local distributor or Belanger, Inc. immediately if
shipment is determined damaged or incomplete.
2) Remove the steel band from the shipping pallet.
3) Locate the parts required to construct 2 sets of Manifold Fittings and the Pendant as shown below.
Locate the two manifold assemblies as well.
Overview

Both assemblies are to be tightened to manifolds as shown below.

Manifold

Manifold

Notice large feed hole on top of Pendant

Nipple

Pendant

Female Adaptor Foam
Spacer

Male Connector
These two pieces are secured together at the
factory using Teflon™ Tape and Liquid Teflon™.
If you must take them apart for maintenance
reasons, BE SURE to apply both products to the
Steel Tee threads before you put them back together.

12 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (248) 380-9681 1MANUL115