Page 36 - Chameleon® Arch Series
P. 36

CHAMELEON® ARCH SERIES


            Installation


            Additional Options: Foam Pods

               Single Foam Pods and Triple Foam Pods
                   8)  Place the airlines in the extruded side of the head beam and then through the nylon
                       protective sleeve that is at each corner of the head beam.

                   Note:  Make sure that the nylon protective sleeve is positioned so that it is not allowing the airlines
                          to rub any of the edges at the slotted area of the head beam corner.

                                         Protective
                                         Sleeve
                                                                            Protective
                                                                              Sleeve













                                             .
                   9)  From the corner of the head beam, you will proceed to run the airlines through the
                       extruded side of the legs.
                   10) Locate the Utility Arch filler strip kit and the remove the two sections that are for the head
                       beam and the four sections that are for the lower half of the Arch leg weldments. Snap all
                       six filler strips in making sure that you are not pinching any of the 1/4” airlines. Refer to
                       the images below for more detail.






















                                       .

                   11) Locate the sections with the slotted holes. These will be used for the angled area of each
                       Arch leg weldments. When positioning these sections, be sure the slotted holes are
                       toward the bottom end of the filler strips.




             32        Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681          1MANUL526
   31   32   33   34   35   36   37   38   39   40   41