Page 17 - Tunnel Support Components
P. 17

TUNNEL SUPPORT COMPONENTS


                       Installation


                       10HP Hydraulic Unit

                                              Dimensions
                                 27” tall       48” wide        18” deep
                           The following shows the major components on the 10HP Hydraulic Unit followed by a brief description.
                           Each of the labeled components will be covered in greater detail later in this  document.  The  10HP
                           Hydraulic Unit is rated @ 15 GPM @ 1000 PSI with a 30 gallon steel tank.
                                                                          Snubber Knob
                             Low Oil Fault Switch                                     Feed
                              (1ELECT-SW437)                                        Pressure   Fluid Feed Manifold
                                                                       Pressure      Gauge    (located at rear)
                                                                      Adjustment
                                      Main Electrical   10HP Hydraulic   Control           Return
                                         Feed        Motor                                Pressure     Fluid Return
                         Fluid Fill                                   (1PUMP410)                        Manifold
                          Cap                                                              Gauge





                                                                                                   Oil Filter
                                                                                                   (1FILTR510)
                                                               Variable Volume Pump

                                                                                                  Oil temperature and
                                                                                                  level Site Gauge
                                                                                                  (1GAUGE250)

                                                     Hydraulic Tank
                                                                                                 Drain Plug


                       The tank comes unfilled; please fill with the proper fluid as described earlier in this document.
                                 •   Fluid Cap: The cap has a 5PSI check valve to prevent moisture from entering the tank
                                 •   Fluid Level Sensor: Detects the hydraulic oil level in the tank. When fluid level is too low, the sensor will
                                     send a signal to the DCC
                                 •   Main Electrical Feed: Supply 208/230/460 power supply from your Motor Starter Panel
                                 •   10HP Motor: Capable of turning the pump to deliver 15 gallons of hydraulic oil per minute
                                 •   Pressure Adjustment Control: Regulates overall pressure distribution to the system
                                 •   Snubber Knob: Must be open to check and/or set the system, then closed
                                 •   Feed Pressure Gauge: Displays overall oil pressure being sent out to the system
                                 •   Return Pressure Gauge: Displays differential pressure across filter. Red indicates the need to change the
                                     oil filter
                                 •   Fluid Feed Manifold: Here you can make adjustments to the 3 individual flow controls for speed adjustment
                                 •   Fluid Return Manifold: All return lines connect here
                                 •   Oil Filter: Oil filter used to cleanse the oil before it gets back into the tank
                                 •   Site Gauge: Visually displays fluid level in the tank as well as the oil temperature
                                 •   Drain Plug: Drain oil here for maintenance
                                 •   Hydraulic Tank: 30 gallon steel tank
                          See you system prints for more details.





                       1MANUL760            Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681       15
   12   13   14   15   16   17   18   19   20   21   22