Page 19 - Tunnel Support Components

TUNNEL SUPPORT COMPONENTS

Installation

10HP Hydraulic Unit

Fluid Feed Manifold
There are three hydraulic feeds located at the rear of the Hydraulic Feed (typical)
10HP Hydraulic Unit. The feeds correspond with the three
components that require hydraulic oil: Conveyor, Gyro
Wrap and the Low Side Washer.

To adjust equipment speed, loosen the locking nut that Locking
corresponds with the component to be adjusted. Using an Nut
Allen wrench, turn the adjusting socket left or right to the (typical)
desired speed (clockwise to decrease the speed, counter Adjusting
clockwise to increase the speed) and tighten the locking Socket (typical)
nut. The Feed Ports are: 1VALVE-HY702.
Although the feeds are labeled, they can be connected in 1VALVE-HY702
any order.
Note: Refer to system drawings for proper hose routing and connections

Main Fluid Return Valve
There are three hydraulic returns located at the right, front
of the on the 10HP Hydraulic Unit. The return fittings
correspond with the three feeds on the Feed Manifold.
Return lines from equipment can be connected to any of
these ports.
Replace the Oil Filter if the return gauge displays in the
red. Oil
Filter

Fluid Return (typical)
Manifold Plug

Note: Refer to system drawings for proper hose routing and connections

1MANUL760 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 17