Page 42 - Foam Bullet™

Foam Bullet™

Maintenance

Routine Procedures

Foam Bullets™
 Check spray nozzles
 Run a test wash to begin each business day
 Inspect all air-lines making sure they are not making contact with sharp objects or in the path of vehicles
 Use a warm rag/towel to wipe Foam Bullet™ of any dirt or debris

Trouble Shooting

Problem Cause Solution
No chemical  Clogged foot valve on suction line  Clean or replace foot valve

 Empty storage tank  Fill storage tank
®
 Chemical pump has lost prime  Prime chemical pump (Flojet or MixStir are self priming)
 Solenoid valve not energized  Check for proper operating voltage

Pulsating or weak  Dirt in solenoid valve  Disassemble and clean solenoid valve
spray
 Kink in hose  Remove any kinks from hose
 Inadequate water pressure  Open water valve to fullest
 Spray holes clogged  Remove the fittings and foam bullets and blow the
screen to remove any film
 Loose or bad fittings
 Disable the Pod and clean with thin wire and blow
through each port
 Check all fittings on the complete system to assure that
they are tight and do not leak
LED is not On or  Connection in Foam Bullet™ is  Verify electrical connection is secure
Flashing loose
 Replace LED light assembly (110634)
 Short in LED light assembly

 If using a Belanger MixStir to supply the Foam Bullets™ refer to that manual (1MANUL450) for troubleshooting
®
®
any issues and to diagnose any repair or maintenance issues.
 If using a Belanger supplied Pulsatron pump assembly with air panel which is a Auto Fluid Injection System
®
(AFIS) to supply the Foam Bullets™ refer to that manual (1MANUL006) for troubleshooting any issues and to
diagnose any repair or maintenance issues.

1MANUL022 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 38