Page 39 - Foam Bullet™

Foam Bullet™

Utility Connections

Electrical Connections: Foam Bullet™ LED

1) Included with the Foam Bullet™ is an electrical enclosure with either a Flash or Non-Flash
24VDC 0.84A power supply that is to be used to power the Foam Bullet™ LEDs, mount this
enclosure in the backroom. Up to six Foam Bullets™ can be connected to the power supply.

Note: The Foam Bullet™ LEDs should have a separate electrical output so that they may be
programmed separately from the Chemical Delivery Device.

2) The LED illuminates the Foam Bullet™ in either Red, Blue or Green depending on how it is
wired. For proper wiring inside of the 24VDC Power Supply Enclosure refer to the Wire
Diagram provided.

Note: Be sure to follow local electrical codes when choosing wiring materials and when
routing electrical wires.

3) Also included with the Foam Bullets™ is a 24VDC Power Cable for each Foam Bullet™. The
Power Cables are to be routed from the Power Enclosure to each of the Foam Bullets™ and
connected, as shown below.

Power Cable to PS
Foam Bullet™

Power Cable to DS
Foam Bullet™

1MANUL022 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 35