Page 35 - Foam Bullet™
P. 35

Foam Bullet™


                       Utility Connections



                       Chemical and Air Connections for a Pair of Foam Bullets™

                        Note: The images in this section will show Foam Bullets™ on the Top Wheel being connected to the
                              Chemical Delivery System. However, the following steps can be used when installing the Foam
                              Bullets™ on any tunnel equipment.

                          8)  Measure the distance from the Tee Fitting to the fitting on the Foam Bullets™.  Be sure to add
                              a few inches to the measurement to have slack in the airline so the Foam Bullets™ can be
                              adjusted. Cut the airlines to the appropriate length.
                          9)  Connect the black airlines for the Compressed Air to the tee and run these lines along the
                              frame and connect them to the Foam Bullets™, refer to the image below.

                                                              Helpful Hint
                         Be sure to cut all of the airlines to the same length to ensure even distribution of the chemical solution to each of the Foam Bullets.












                                                  Black 3/8” Airline for
                                                    Compressed Air    Field Supplied
                                                                        3/8” Tees
                                                                              Black 3/8” Airline for
                                                                               Compressed Air




                                                   Clear 3/8” Airline for
                                                   Chemical Solution





                            Airline Connections
                             to Foam Bullet™









                          10) Connect the clear airlines for the Chemical Solution to the tee and run these lines along the
                              frame and connect them to the Foam Bullets™, refer to the image above.
                          11) Turn on the MixStir®, make sure that the solution is spraying out of the Foam Bullets™
                              properly.
                        1MANUL022        Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681   31
   30   31   32   33   34   35   36   37   38   39   40