Page 31 - Foam Bullet™
P. 31

Foam Bullet™


                       Installation


                       Mounting the Oval Mount to a Frame (Signature Series)

                       In order to mount the Foam Bullets™ to an Oval Frame such as the Signature Series frame you will
                       need to cut out a section of the colored accent strip at the desired location. Once that is done follow
                       the instructions and images below.
                       Note:  When installing the Wedge Plates, be careful not to scratch the powder coating on
                              the frame.

                          1)  Locate the Oval Mount Kit which contains the following components parts.
                                                                            3/8-16 x 1-1/4” Fastener,  3/8” Lock
                                      Oval Mount Kit      Mounting Wedge
                                                                                 Washer & Flat Washer













                          2)  Loosen  the  Mounting  Wedge  fasteners  slightly  on  the  Oval  Mount.  Insert  the  mounting
                              wedges into the channel on the Oval Frame, as shown below.

































                          3)  Position  the  Mounting  Wedges  so  that  the  flat  edges  are  seated  against  the  walls  of  the
                              channel then tighten the fasteners to secure the Oval Mount to the frame.




                        1MANUL022        Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681   27
   26   27   28   29   30   31   32   33   34   35   36