Page 111 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 6 Frame and Carriage Assembly

Adjusting the Front and Rear Sonar Units
The Sonar Mount can be pivoted on 3 different axis’. The instructions on this page will help you understand the proper way to adjust it.
1) Loosen the setscrews to adjust the vertical positions at either the Base or on the End (Axis 2 and 3) as shown in side
view below.

Setscrews (typical)
Axis 3 Axis 2
Mount
Base

Axis 1 Sonar End

Side View (transparent)

2) Loosen the setscrews to rotate the end horizontally (Axis 1) as shown above and below. Image below shows “front view”.

3) Adjust until Sonar Unit is level with the floor (front to rear of vehicle) and tilted 1º toward center of vehicle (left to right).

CAUTION

DO NOT move the Carriage Assembly with the doors open.

CAUTION

CONFORM THAT THE SONAR UNIT

CLEARS THE MAIN CROSSBEAM PRIOR

TO RUNNING.

1MANUL290 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 6-49