Page 13 - FreeStyler® E-1063 Programming and Operation Manual

E-1063 PROGRAMMING AND OPERATION

Chapter 1 General Machine Operation

Vehicle Flow

Light Operation
Enter Slow (DRIVE FORWARD) Lamp
This lamp will turn on when a Package is entered into the Loader (POS has sent the package selection). It will
remain on until the vehicle pulls on to the Treadle. Once on the Treadle the Entrance Slow lamp will turn off and the
Entrance Stop (WAIT) lamp will turn on.

Enter Stop (WAIT) Lamp
This lamp will turn on if the wash cycle is in progress, if the vehicle just finished wash cycle and is being evaluated
for leaving the bay (vehicle exchange active), or if the machine is Homing the Carriage.

Exit Stop Lamp
This lamp will turn on when the vehicle is on the Treadle and the wash cycle is active.

Exit Drive Forward Lamp
This lamp will be latched on as soon as the vehicle enters the bay (Wash Package shifted from Loader to Wash). It
will remain latched on until the vehicle is on both treadle Doors. It will come on again when the vehicle is being
evaluated for leaving the bay (Vehicle Exchange active). It will also turn on if the vehicle pulls completely off of the
Treadle during the wash cycle and the last Treadle condition was NOT Exit Treadle Door down and Enter Treadle
Door up.
Exit Back Up Lamp
This lamp will turn on if the vehicle pulls completely of off the Treadle during wash cycle and last Treadle condition
was Exit Treadle Door down and Enter Treadle Door up.
Point of Sales Operation
Input Operation

The system is equipped with four inputs that a POS may utilize to select a wash package (insert package into
Loader). These inputs can be used in direct or binary mode. Most commercial POS systems unitize the direct mode.
In direct mode, each of the four inputs inserts a different package into the Loader. Each of the inputs can be toggled
to run one of two Packages. The Packages for the direct inputs are: (Input X15 is Package 1 or 5), (Input X16 is
Package 2 or 6), (Input X17 is package 3 or 7) and (Input X20 is Package 4 or 8). If the system is in binary mode,
each input is given a value. When one or multiple inputs come on at the same time, the sum of the value associated
with each input is added up and the total is the Package number inserted into the Loader.

Output Operation
The system is equipped with an output that signals the POS in one of two different methods. These methods are:
(Wash In Use) and (Wash Done). If Wash In Use is selected, the output will typically turn on when the vehicle enters
the bay (Wash Package shifted from Loader to wash), and then turns off when that vehicle is no longer being
evaluated for leaving the bay (Vehicle Exchange active). If the Wash Done is selected, the Output will be on most of
the time, it will turn off for two seconds as soon as the wash cycle is done.
Pager

System may be purchased with a modem for paging out if a Fault occurs. This system works with most cell phones
and pagers and does not require hiring a third-party service to interpret the page and send it to the cell phone or
pager. The system sends out numerical data of three digit site number and a four digit Fault Code. Up to two
numbers can be called to receive a page. An analog phone line is required for this service. Digital phone services
will damage the modem.

1MANUL224 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1-5