Page 11 - Pivoting Wheel Stinger™ Mix and Match

PIVOTING WHEEL STINGER Mix and Match

Installation

Frame Assembly and Placement

The Pivoting Wheel Stinger’s supporting structure consists of three main features. These being
theOverhead Assembly, Upright Utility Leg and the Upright Secondary Leg.
1) Determine the location in which the Pivoting Wheel Stinger
will be set. Be sure there is no equipment in the working
envelope that will interfere with its operation. Now determine
from which side the utilities will be fed (driver side or
passenger side). Locate the Pivoting Wheel Stinger Overhead
Assembly and lay it out so that it is oriented properly with
respect to its utility feeds being on the equipment room side.
2) Using a fork-lift, raise the Overhead Assembly to a height
above the length of the legs.

Note: Be sure to clamp it to the forks before lifting.
3) Locate and identify the 2 leg assemblies. The one with the oil
canister mounts are for the utility side leg. See image at right
for identification.
4) Attach the side plates with four supplied 1/2-13 x 2” ARMOR Leg with Oil Canister Mounts
COAT fasteners that run threw the side plates, top mount into
the tapped holes in the top of the main upright leg as shown below.

5) Secure the other leg into place.

1MANUL586 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 9