Page 12 - Pivoting Wheel Stinger™ Mix and Match

PIVOTING WHEEL STINGER Mix and Match

Installation

Frame Assembly and Placement

6) Insert one of the supplied 1/2-13 x 5-1/2” ARMOR fasteners (located in the accessory box) with the
appropriate washer through the main upright leg, through the side plate and secures into the tapped hole of
the side plates clamp seat as shown below. Repeat the process on the opposite leg.

7) Measuring from the inside of the passenger side guide rail set the inside edge of the base plate 42-7/8” out
as shown below.

42-7/8”

8) Square the Pivoting Wheel Stinger by assuring the same measurement at the upper and lower portions of
the legs as shown below.

Same as Below

Same as Above

10 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 1MANUL586