Page 44 - Top Wheel Mix & Match
P. 44
TOP WHEEL Mix and Match
Installation
Utility Connections
Electric Drive Motor Feed
Note: The image below shows the standard 1HP electric motor/gearbox assembly.
The same routing applies to all electric drive assemblies.
1) Route electrical feeds to the motor as shown below and follow wiring directions on motor to
make proper connections.
Tie-wrap cable
and hose
together
Water
Feed
Electrical
Feed
Image above shown with stauff clamps in place
It is recommended that a licensed electrician is contracted to perform all electrical installations.
2) Locate the green plastic stauff clamps and secure them to the side of the driver side arm as
shown below using 1/4-20 x 1-1/4” socket head fasteners. The mounting plates are designed
to accommodate both electric and hydraulic drive. For electric drive be sure to insert the
socket head fasteners into the top and third holes as shown below.
Use these holes for electric drive
Clamp Mounts
40 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL749
