Page 42 - Top Wheel Mix & Match
P. 42
TOP WHEEL Mix and Match
Installation
End Caps
1) Assuming the system has been flushed and the correct configuration for the weights have
been figured out, look in the Accessory Box and locate the 2 black plastic End Caps and the
tube of Loctite glue.
2) Take one of the Caps and notch off one side. This will be placed on the driver side Arm to
allow room for the weld.
3) Locate the supplied glue and apply to the inside of Caps on all 4 sides and then secure one
Cap to the end of each of the Arms.
4) Drill a 1/4” hole at the upper and lower end of each End Cap. The upper hole is to allow for
the scale to get the weights right and the lower hole is to let any water drain from the frame.
Passenger Side (Before) Passenger Side (After) Driver Side (Before) Driver Side (After)
Install Cap Here
Install Cap Here
38 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL749
