Page 9 - Funksjoner SCAFFPLANNER - NO

12. The preferred bay length. Around the middle of the scaffold, a shorter bay will be used if
needed. And even a gap if the total length does not match sum of the supported bay lengths.
13. The function will suggest where to place adjustments, diagonals and anchoring. If you want
to edit these setting, check for “Ask for adjustments”
14. Set the offset of the scaffold base. This means connection point on the base plates where the
standards are connected. (Not the offset of the plate). This value is according to the
reference level of the base line.
15. Set the height distance between the decks
16. Set the offset of the highest deck. First time you use the function it will calculate this value
based on all levels in the project. If the offset does not match the multiplication of the height
between the decks, it may result in a lower offset than you set.
17. Set the default extension of the base plates. Mind that this is just a default value. You can
change this value individually on each base plate later.
18. Set the height from the scaffold base offset to the first deck.
19. Set the height of the standards. The function will start adding standard heights from the
connection point of the base plates. The upper standard will be shorter to match the height
at top.
20. Set the height of the standard at the top deck.
21. Build scaffold when settings are ready. After building one scaffold of one base line, you can
continue click on next base line. Press ESC when ready. You will then get back to the settings
and may do some changes and continue build scaffolds.
22. Cancel will not save the settings and end the function.
23. Close will save the settings and end the function without building any scaffold. Some other
functions are using the settings. You should then check settings here and just Close.

Adjustments

If you checked “Ask for adjustments” you will get access to this dialog and make changes to
placement of adjusted bays, diagonals and anchoring. Bay length is shown of each bay. Any gap is
shown in gray and the length is presented below the gap. Anchoring is shown as red donuts.
Consoles as blue triangles. The double lines at the first and last bay indicates connection to next
scaffold at the corner.