Page 14 - Funksjoner SCAFFPLANNER - NO

1. Click in the list and use the arrow up and down for changing the priority list of the planks.
When adding planks in the bays it will optimize the use of widths according to the total
calculated width. It fills up with the first one and calculates when it should continue with the
second one to minimize the gaps.
2. If both planks and toe board are unchecked, only tubes will be added on the standards.
3. Select if all or only selected deck should be covered. Point on the standards above the
wanted deck.
4. The tubes, toe boards, and planks should be longer than the gap. Give the minimum overlap
distance. According to available lengths of the equipment, the shortest length available will
be used.
5. Define the distance from the standard connection points where the tubes should be located.
The value can be negative.

Single Tube Gap Cover

Insertion of single tube and couplers. You are prompted to select two standards. Point nearby the
connection point of the standards. The defined distance settings in the main Gap Cover command is
used when inserting the tube. If you need to change this value, just open the dialog of the Gap Cover
command, change “Dist. From Std. conn” and close the dialog.