Page 437 - Wurth Total Catalogue

PLASTIC FRAME-FIXING ANCHORS W-UR 10
42.1

Anchor Dimensions
Anchor Diameter [in mm] W-UR 10
Total Length l [in mm] 80 100 115 135 160
Maximum Mounting Height d [mm] 10 30 45 65 90
a
Art. No. ®
Plastic frame-fixing anchor W-UR AW 30 drive
with countersunk screw W-UR 10 and
W-UR 10 A4: 09 12 810 401 09 12 810 501 09 12 810 402 09 12 810 502 09 12 810 403 09 12 810 503 09 12 810 404 09 12 810 504 09 12 810 405 09 12 810 505
®
Galvanised Steel, Yellow Chromated AW 40 drive
Stainless Steel A4
Packing unit Pack Qty. 50
Art. No. AW ® 25 and SW
Plastic frame-fixing anchor W-UR F 10 drive
with hexagon screw and W-UR F 10:
pressed-on washer AW ® 40 and SW 09 12 810 601 09 12 810 701 09 12 810 602 09 12 810 702 09 12 810 603 09 12 810 703 09 12 810 604 09 12 810 704 09 12 810 605
13 drive
Galvanised Steel, Yellow Chromated W-UR F 10 A4:
Stainless Steel A4 SW 13 –
Packing unit Pack Qty. 40

1) The approval takes account of the part-safety coefficients of the resistances and a part-safety coefficient of the effects of γF = 1.4. In case of a combination of tensile and transverse loads, please observe ETAG 020 Appendix C.
AUS. pub. 11/10 © 3) Maximum short-term temperature.
2) Maximum long-term temperature.
4) Other brick types, raw densities, minimum compressive strengths, or temperature ranges can be found in the ETA-08/0190 approval.
5) The brick geometry should be matched to the approval ETA-08/0190.
6) If the drilled hole is created through impacting or hammering, the permissible load is to be determined via tests on the building.
06 2153