Page 783 - Foton Workshop Manual - Auman EST-M

Engine section – Engine (Cummins ISF3.8) EG - 267

Camshaft position sensor IN
Overview
1. Camshaft position sensor is mounted on the end position of camshaft for measuring engine speed and DI
determining engine phase. The camshaft signal sensor together with the crankshaft position sensor
provides the correct stop signal for Cylinder 1 to ECU. If this sensor fails, the engine is hard to start EG

2. After the crankshaft position sensor becomes invalid, the camshaft position sensor can substitute the

crankshaft position sensor to start the engine. The failure of camshaft position sensor is presented
mainly in that the engine is hard to start TR

Change
AX
1. Switch off the ignition switch

2. Disconnect the cable of battery negative pole
FR
3. Flip over the cab to the front

4. Remove the camshaft position sensor
ST
a. Disconnect the camshaft position sensor connector.

BR

BW

EL

b. Remove the camshaft position sensor fixing bolts.

c. Remove the camshaft position sensor.

Caution

Clean the installation surface after dismounting to

ensure no grease dirty

5. Install camshaft position sensor

a. Install the camshaft position sensor into the mounting hole and tighten the camshaft position sensor fixing

bolts.

Torque: 9~12N•m

b. Connect the camshaft position sensor connector.

Caution

Install it by pressing it in. Do not knock the sensor into the installation hole by any impacting tool (such

as hammer, etc.)

6. Return the cab to connect the battery cable

EG-267