Page 1055 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY 34-25

(d). Measure the radial clearance between the
planetary gear and the planetary gear shaft
with jawed vice and dial indicator.
Radial clearance between planetary gear
and planetary gear shaft: ＜ 0.06mm
If the radial clearance exceeds the limit,
check the wear of the planetary gear and
the planetary gear shaft and replace them
if needed. (Refer to "Chapter 34. Axle &
Transmission Shaft - Front Differential
Assembly, Overhaul")
NOTICE
Hold the planetary gear shaft with jawed vice
after wrapping it with soft cloth, or it may cause
damage.
(e). Measure the radial clearance between the
half axle gear and the differential housing
with jawed vice and dial indicator.
Radial clearance between half axle gear
and differential housing: 0.05~0.1mm
If the radial clearance exceeds the limit,
check the wear of the half axle gear and
the differential housing and replace them
if needed. (Refer to "Chapter 34. Axle &
Transmission Shaft - Differential Assembly,
Overhaul")

11. Remove the differential bearing
(a). Remove the differential bearing inner rings
from the differential housing with a puller.
NOTICE: 34
It is important to store the differential bearing
inner ring and the differential bearing outer ring
together. Store them by left/right separately.

Page 1055