Page 1060 - Foton Workshop Manual - Aumark (BJ1099)

34-30 AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY

19. Check the engagement mark of the driving and driven gears (Refer to "Chapter 34
Axle & Transmission Shaft - Front Differential Assembly, Checking & Adjustment")
20. Check the pre-tension of the differential bearing (Refer to "Chapter 34 Axle &
Transmission Shaft - Driving Gear, Checking")

21. Install the rear cover
(a). Apply some sealant on the interface
between the rear cover and the main
reducer and install the rear cover in place.
(b). Tighten the retaining bolts of the rear cover.
Torque : 15~22N•m

(c). Connect the ventilation pipe and install the
retaining clips.

22. Install the front main reducer assembly (Refer to "Chapter 34 Axle & Transmission
Shaft - Front Main Reducer Assembly, Replacement")
23. Install the front half axle (Refere to "Chapter 34 Axle & Transmission Shaft - Front
Half Axle,Replacement")
24. Fill up the gear oil (Refer to "Chapter 34 Axle & Transmission Shaft - Main Reducer
Gear Oil,Replacement")

Page 1060