Page 1057 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY 34-27

14. Measure the gear side clearance between
half axle gear and planetary gear
(a). Measure the gear side clearance between
the half axle gear and planetary gear with a
dial indicator.
Gear side clearance between half axle
gear and planetary gear: 0.05~0.1mm.
Maximum: 0.2mm
If the clearance exceeds the limit, check
the end clearance of the half axle gear.
(Refer to "Chapter 34 Axle & Transmission
Shaft - Front Differential Assembly,
Checking & Adjustment")

NOTICE:
Hold the half axle gear and the planetary gear close to the differential housing, fix any of
the two gears and measure the central point of the other gear surface. Ensure the head of
the dial indicator is vertical to the measured gear surface. Measure all four gears at three
or more points on each gear.

15. Install the driven gear
(a). Check for damage and wear on the driven gear surface and repair or reaplcee
it if needed. (Refer to "Chapter 34 Axle & Transmission Shaft - Front Differential
Assembly, Overhaul")
NOTICE:
• Replace the driving and driven gears in pairs.
• Repair it for minor damage.
• And replace it in case of scratch, peeling, corrosion point, crack or overly wear.

(b). Place the driven gear in place.
NOTICE: 34
When installing an old driven gear, clear thread
sealant and other impurities in the gear thread
hole.

Page 1057