Page 1059 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY 34-29

(d). Install the differential bearing spacer.
NOTICE:
If no replacement, install it by left/right as marked.
Ensure the spacers on both sides have the same
thickness.

17. Install the differential bearing cap
(a). Put the differential bearing caps in place as
marked.
NOTICE:
Install them as marked.

(b). Tighten the retaining bolts of the differential
bearing cap.
Torque : 54~64N•m

34

18. Measure the run-out of the driven gear
(a). Rotate the driven gear by hand.
(b). Measure the runout on the mounting surface
of the driven gear with a dial indicator.
Standard: 0.1mm
If the runout exceeds the limit, replace a
new one. (Refer to "Chapter 34 Axle &
Transmission Shaft - Differential Assembly,
Overhaul")

Page 1059