Page 2071 - Foton Workshop Manual - Sauvana
P. 2071

DIAGNOSIS-SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM (SRS)                   62-19

                 Is the inspection result normal?
                 Yes>To step 2.
                 No >Replace or charge the battery.


                 2.     DTC Test
                                                                                                                    62

                                                            (a).   Turn off the ignition switch and all the
                                                                   electrical appliances and connect the
                                                                   vehicle diagnostic device to the diagnose
                                                                   interface.
                                                             (b).   With the ignition switch: "ON", read and
                                                                   clear the DTC with the vehicle diagnostic
                                                                   device.
                                                             (c).   Turn off the ignition switch and all the
                                                                   electrical appliances and after 3~5 seconds
                                                                   reset the ignition switch on the "ON" gear.
                                                             (d).   Read the DTC with the vehicle diagnostic
                                                                   device again.
                                                 fuwx62176


                 Check if the trouble code exists?
                 Yes>To step 3.
                 No >For accidental faults, check whether the plug of the personal detection device
                         connector is loosen and eroded.


                 3.     Check seat weight sensor


                 (a).   Disconnect seat weight sensor connector D08.


                                                            (b).   Use a multimeter to measure the resistance
                                                                   between No. 2 terminal and No. 1 terminal
                                                                   of connector D08.
                                                                   Standard resistance:

                                                                     Connect the pin by       Standard value
                                                                          multimeter
                                                                        D08(1) - D08(2)            ≥ 1MΩ



                 Is the inspection result normal?
                 Yes>To step 4.
                 No >Replace seat weight sensor.









                                                                                                     Page 2071
   2066   2067   2068   2069   2070   2071   2072   2073   2074   2075   2076