Page 2075 - Foton Workshop Manual - Sauvana
P. 2075

DIAGNOSIS-SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM (SRS)                   62-23

                 Is the inspection result normal?
                 Yes>To step 2.
                 No >Replace or charge the battery.


                 2.     DTC Test
                                                                                                                    62

                                                            (a).   Turn off the ignition switch and all the
                                                                   electrical appliances and connect the
                                                                   vehicle diagnostic device to the diag nose
                                                                   interface.
                                                             (b).   With the ignition switch: "ON", read and
                                                                   clear the DTC with the vehicle diagnostic
                                                                   device.
                                                             (c).   Turn off the ignition switch and all the
                                                                   electrical appliances and after 3~5 seconds
                                                                   reset the ignition switch on the "ON" gear.
                                                             (d).   Read the DTC with the vehicle diagnostic
                                                                   device again.
                                                 fuwx62176


                 Check if the trouble code exists?
                 Yes>To step3.
                 No >For accidental faults, check whether the plug of driver side impact sensor connector is
                 loosened and eroded.


                 3.     Check the harness disconnection


                 (a).   Disconnect driver side impact sensor connector D61 and SRS ECU connector C27.


                                                            (b).   Use a multimeter to measure the resistance
                                                                   between No. 1 and No. 2 terminal of driver
                    OFF
                                                                   side impact sensor connector D61 and
                                                    C27
                                                                   No.26 and No. 27 terminal of SRS ECU
                    50 49 48 47             40     37
                                                                   connector C27, respectively.
                    25 24  23 22  19 18  17 16  14 13  11 1
                                                                   Standard resistance: (check whether there
                            D61              50  49
                                                                   is an open circuit)

                       1   2
                                                                         Connect by           Standard value
                                                                          multimeter
                          1  2
                                    Ω                                   D61(1) - C27(50)           ≤ 2 Ω
                                                                        D61(2) - C27(49)           ≤ 2 Ω
                                                 fuwx62169







                                                                                                     Page 2075
   2070   2071   2072   2073   2074   2075   2076   2077   2078   2079   2080