Page 477 - Wago_AutomationTechnology_Volume3_2015_US.pdf

6

475

System bus 1: RD+/TD+
Input Output 2: RD--/TD-- Block diagram of an output
3: TD--/RD--
4: TD+/RD+
5: GND Digital Output Supply
Housing: Shield X1 ... X4
M12 B coded
M12 M12

Output 0 ... 7
Digital Outputs X1 ... X4 1: 24 V
(two outputs/connector) 3: 0 V U
A
10 nF 10 nF
Logic
5 5 Diagnostics 0 ... 7
5: Shield
270 pF
M12 A coded
4: Output A
2: Output B
Housing: Shield 5
Output Error
Supply 1: 24 V U 0 ... 7 F Module
Input Output 2: 24 V U LS mount
3: 0 V U A
4: 0 V U LS
A
M12 A coded

Technical Data Technical Data
Information on actuator selection: Isolation: 6
Front-end cycle time 90% (hardware) max. 0,5 μs Channel – Channel No
Edge steepness T ON/OFF : typ. < 0,2 μs U LS , U A , system bus 500 VDC each
Front-end jitter/skew (output) < 0,2 μs Configurable functions:
Protection against reverse voltages ≤ 0.5 A Inversion (per channel) On/off
Type of load Inductive, resistive loads and lamps Substitute value strategy (per channel) Switch substitute value/hold last value
Switching frequency Inductive load upon request Substitute value (per channel) 0/1
Resistive load upon request Manual mode (per channel) On/off
Lamp load upon request Manual mode value (per channel) 0/1
Type of protective circuit External protection (e.g., recovery diodes) Online simulation (per channel) Lock/Unlock; simulation value: 0/1;
Operating state influence on output: diagnostics
PLC CPU stop Acc. to substitute value strategy I/O diagnostics:
Fieldbus disruption Acc. to substitute value strategy I/O diagnostics (per channel) Overtemperature, actuators
S-bus (system bus) disruption 0 V status I/O diagnostics (per module) Undervoltage (U LS + U A )
Supply voltage under rated voltage Process image:
tolerance 0 V status Process data width 1-byte data + status
Interruption of supply voltage 0 V status LED indicators:
Output operation Non-latching SB: System bus status LED (green/red/orange)
Overload behavior Automatic restart F: Error status LED (red)
System bus: 0 ... 7: Output signal status LED (yellow/red)
Connection type (3) M12 connectors, B coded, 5 poles, U LS + U A : Supply status LED (green)
shielded Indicators Non-latching
Standards and approvals:
Conformity marking 1
r UL 508

General Specifications
Dimensions (mm) W x H x L 50 x 35.7 x 117
Weight 270 g