Page 109 - Parker - Vacuum products

Catalog 0802-E Vacuum Generators
Replacement Components & Cautions CVXCEK Emergency Stop Vacuum Generators

Discrete kits Emergency Stop (AE1)
PSCEKD1A - M12, 110VAC Blow-off (B1)
Vacuum (V1)
PSCEKN1A - M18, 110VAC Sensor (S1)
PSCEKN3A - M18, 24VDC
PSCEKD3A - M12, 24VDC Sensor (S2)
Vacuum (V2)
Blow-off (B2)
Emergency Stop (AE2)

Output Output Output Output
L A B
K M N B
Channel 1 Channel 2 J T U P C
H S R D Channel 1 Channel 2
G F E
Input Input
Sensors Sensors
Generator Selection

MCA, CV, CV-CK

PL1-CB10, Valve cable MC22-CB10 Valve Cable
Black Wire, Solenoid B, vacuum off (Connects Power Source to the Air-Economizing
Red Wire, Common & Blow-off Release Pilot Valves) CHF
White Wire, Solenoid A, Vvacuum on Positive “+” (Red Wire)
Negative “-” (Black Wire)
MC22
Black
Red
White
1000mm .83 MC72
(21mm)
1000mm
CEK

CVXCEK

ENC244 ! Cautions
Cover
Do not use or expose the CEK with fluids or corrosive gases. MPS-23
Vacuum Venturi’s are designed to be used with non-lubricated,
non-corrosive, compressed air.
Do not operate CEK generators outside the temperature MVS-201
range and pressures listed in the specifications section of this
catalog. Regulate the compressed air to 70PSI and filtrate with
a maximum 40 micron filter. Non-lubricated compressed air will
maintain the life and vacuum level of the generator. Generator Accessories
Check the insulation of all lead wires after installation to avoid
shorts. Properly secure all lead wires to avoid stress or
repeated movement that may fray lead wires.
Some electrical components are diode or zener diode Glossary
protected. When installing solenoids and sensors, check
the polarity of the component before applying power. Apply
the appropriate voltage to the solenoids and sensors.
Inappropriate voltage, shorts, or surges may damage the
circuitry.

B39 Parker Hannifin Corporation
Pneumatic Division
Richland, Michigan
www.parker.com/pneumatics