Page 45 - Parker - Energy Products Division - Multitube (Instrument and Heat Trace Tubing Products)

Process Control & Analyzer Systems
Catalog Number 4200-M-2
Back to Table of Contents

CL— Constant Wattage Electric Trace Tubing —
Low Temperature Maintenance Electrical Specifications:

Heater type 4 W./ft. 11.4W./ft.
®
Insulation PFA Teflon® 600 V rated PFA Teflon 600V rated
Bus wire size 12 AWG 12 AWG
Heating zone length** 18" (45.7 cm) and 24" (61 cm)

Part Power Consumption Voltage Maximum Circuit Current A/ft (A/m)
Number W/ft (W/m) Length*** ft (m)
Series

CL 4 120 340 0.033
(103.6) (0.108)
(13.1)
240 680 0.017
(207.3) (0.55)
CL 11.4 120 200 0.095
(61) (0.312)
(37.4)
240 400 0.0485
(122) (0.156)

***Based on 10% power drop.
For recommended temperature controller, see 4012-01145
(G.P. areas) and 4012-01147 (Hazardous locations).

Ground Fault Equipment Protection Devices (GFEPDs):
Approvals:
The IEEE standard (515-1989) for heating cables requires
Ordinary Locations the use of GFEPDs with a nominal 30 milliampere trip
level for “piping systems in classified areas, those areas
FM – Factory Mutual Approved
requiring a high degree of maintenance, or which may be
Hazardous (Classified) Locations
exposed to physical abuse or corrosive atmospheres.”
FM – Factory Mutual Approved

Class I, Division 2, Groups B, C and D
Class II, Division 2, Groups F and G
For performance characteristics see next
Class III, Division 1 and 2
page.

**Installation Note:
Caution: Cutting beyond heating zone
indentation will result in an unheated
section of the heater wire for the balance
of the heating zone length. The bus wires
MUST NOT be connected together on the
termination end!

Parker Hannifin Corporation
41 42 Energy Products Division