Page 45 - STARTER KIT ROOM ATTENDANT

STARTER KIT | HK-Room Attendant

Task 10: Clean the Toilet and Bath

OPERATING PROCEDURES STANDARD(s)

1. Turn on lights and fan, replace busted bulb if any and T&B is clean from ceiling to floor, sanitized, fresh smelling, dry
report noisy exhaust fan to maintenance department. and without water spots and dust.
Exhaust fan vent should be free from dust and dirt.
2. Empty and wipe trash can with dry rag. Replace plastic
liner if torn or with wet trash. Shower curtain has no mildew/ mold.

3. Remove cobweb, stain and dust on the ceiling. T&B tiles should be clean, dry and shiny.

4. Flush the water closet, shake the water to mix sand and Scrubbing is done from the right side of the T&B clockwise or
water sediments as flows. counter clockwise to the left or right side of the door.

5. Spray toilet bowl (around and under the lip area of the Toilet bowl is shiny white without stain streaks has no ring.
bowl) with disinfectant, leave for ten (10) minutes while Toilet tank water level should be half or three fourths full.
attending to other task/s. There is no continuous flow of water from the tank.
In scrubbing the floor, start from the farthest corner going out
6. Pullout the shower curtain. to the bathroom door.
Tub or Jacuzzi has no water marks, soap film and hair strands.
7. Scrub the wall tiles, faucet knobs, faucet, shower heads, Start from the right or left side of the door from top to bottom
bidet shower, tissue and soap rack with all-purpose clockwise or counter clockwise to the left or right side.
cleaner (APC) and scrubbing pad/foam. T&B fixtures are functioning well, do not leak, in correct
position, dry and spotless.
- Use rubber foam for marble. Glasses are clean, without smell, sanitized, dry, without
- Shower knobs and faucet smudges and finger prints.
- Switches and plates
- Jacuzzi or bathtub
- Toilet bowl (seat cover and tank)
- Flooring
- Wipe both sides of the door with a damp clean
rag.

8. Wash the water closet surfaces down to the toilet bowl
rim and base.
- Scrub the outside surface of water tank and
toilet bowl down to the base using APC and
sponge.
- Scrub the inside of the bowl going down the rim
using toilet bowl APC and scrubbing pad.
- Clean the inside surface of the water tank using
APC and brush with handle.
- Flush the dirty water. Make sure all dirt is
flushed down also.
- Check toilet tank for clear water and water
level.
➢ Check tank for functionality, replace if broken.

9. Scrub the floor tiles and brush the drain strainer.
- Pay attention to grouts with mildew, soap marks
and stains.
- Remove floor drain, scrub and brush holes.

40