Page 19 - QR CIMAR POWER TROWEL CPT-36

CPT-36/F220/TEESIN/MAN/01/15
Trowel Turn, engine at idle
Cannot change speed.
Trowels blades wearing
unevenly.
Machine jumps on floor.
Oil leak.
V-Belt wears quickly, and
cannot adjust the speed.
Compile by CJ
- Worm gear - Worm gear
(countershaft) of (countershaft)
-Main gear - Main gear
5. Gearbox seized 5. Replace Gearbox
1. Idle too fast 1. Adjust idle speed.
2. Belt too tight 2. Loosen belt.
3. Clutch Seized 3. Replace clutch
4. Pulley out 4. Realign pulley
alignment
1. Blade assembly is 1. Clean blade
covered with assembly of excess
excessive concrete. concrete.
2. Connection between 2. Tighten the
blade housing and connection.
crankcase is loose.
1. Blade arm bent 1. Replace blade arm
2. Adjust the screws
2. Adjusting screws
correctly.
(carriage bolts)
incorrectly set.
1. Concrete hardened 1. Remove concrete.
2. Replace trowel
on the bottom of the
blade
plate. 3. Replace trowel
2. Trowels unevenly arms
4. Replace main shaft
worn.
3. Trowel arms bent
4. Main shaft bent
1. Crankcase seal is 1. Replace crankcase
seal.
damaged.
2. Replace carburetor.
2. Carburetor is 3. Check and readjust
damaged. seal or replace the
correct seal if
3. Gap between shaft necessary.
4. Replace seal.
and seal too wide. 5. Check and Refer to
engine manual
4. Oil seal is damaged. 6. Replace relief valve.
7. Remove excessive
5. Engine leaks oil.
8. Replace with a new
6. Relief valve broken set screw.
1. Readjust the V-Belt.
7. Too much oil in 2. Replace the correct
V-Belt.
gearbox 3. Check the clutch
8. Set screw missing in
cover.
1. V-Belt is not in line
vertically with the
pulley.
2. Wrong v-belt
For technical questions, please call +65 – 66431213 17
For Products Enquiry, please call +65 - 67581211