Page 1046 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.4 8-7

4 2006 Softail: Electrical

NOTE Rear wheel may have to be raised slightly to allow for inner See Figure 8-5. Remove two bolts (1) from rear inner fender. Bend upper right corner of fender towards rear tire and lift upward to clear hole in fender (2) from tab on See Figure 8-3. Remove circuit breaker (2), speedome- ter sensor (3), turn signal/turn signal security module (5) and vapor valve (7) from tabs in electrical panel. NOTE If security siren is not installed, remove security siren connec- tor [142] from receptacle in electrical panel. If installed, remove security siren (6) from tabs in electri- On California models, remove canister tubing from elec- Cut electr

fender removal. rear fork (3). cal panel. trical panel. slot in transmission case. 2 5

1
6.
5.
7.
8.
9.
4.
7 Figure 8-3. Electrical Panel
See Figure 8-3. All Softail models use a panel under the rear
fender to mount important electrical components. This electri-

ELECTRICAL PANEL
Vehicle speed sensor: VSS (3) [65]. Turn signal module (TSM) or turn signal security module (TSSM) and connector (5) [30]. Master circuit breaker (2). Security siren connector (6) [142]. Use the following removal and installation information to ser- vice electrical panel components. 1WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Disconnect negative battery cable. Remove right side saddlebag if present. Turn signal/turn signal security and connector

GENERAL cal panel contains: REMOVAL Remove seat. Fastener (2) Master circuit breaker Speedometer sensor connector [65] Cable strap module and connector [30] Security siren [142] Vapor valve s0562x8x

HOME ● ● ● ● 1. To 2. 3. 1. 2. 3. 4. 5. 6. 7.