Page 1047 - 2006 HARLEY FLSTCI SERVICE MANUAL

Figure 8-4. Siren Connector Receptacle 2 3 Hole in rear inner fender Figure 8-5. Inner Fender

8491 s0300x8x 1 Bolt (2) 1. 2. Tab on rear fork 3.

See Figure 8-3. Place electrical panel into position by installing tab on panel into slot in bottom of transmission Install electrical panel fasteners (1). Tighten fasteners to NOTE On California models, connect canister tubing to electrical panel before installing vapor valve. Canister tubing is installed Install circuit breaker (2). For more information on circuit breaker, see 8.13 MAIN CIRCUIT BREAKER. Install turn signal/turn signal security module (5). NOTE See Figure 8-4. If security siren is not installed, install secu- rity siren connector [142] into receptacle in electrical panel. See Figure 8-3. If vehicle is equipped with a se

INSTALLATION 60-108 in-lbs (6.8-12.2 Nm). to the right of vapor valve tubing. Install vapor valve (7). Install speedometer sensor (3). siren, install security siren (6). tab on rear fork (3). Install right side saddlebag if removed. Connect negative battery cable. or serious injury. (00070a) 2006 Softail: Electrical

HOME 1. case. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Install seat. 12. 8-8