Page 1084 - 2006 HARLEY FLSTCI SERVICE MANUAL

side auxiliary lamp and place over left side auxiliary
lamp. Adjust the right side auxiliary lamp as necessary
so that the entire high intensity zone is both below and to
Leaving the headlamp covered, remove cover from right
the right of the right side auxiliary lamp centerlines (5).

Tighten auxiliary lamps on FLSTC models. a. See Figure 8-52. Loosen screws (5) to detach turn signal lamps (1) from mounting bracket (3). Insert flare nut socket at bottom of turn signal mounting bracket and tighten locknut to 18 ft-lbs (24.4 Nm). Start two screws to secure turn signal lamp to mounting bracket. Verify that conduit fits in slot at back of bracket and is not pinched. Alternately tighten screws to 36-60 in-lbs (4.1-6.8 Nm). Tighten auxiliary lamps on FLSTN models. Loosen screw (23) and remove Figure 8-54. bezel (16) from auxiliary lamp (24). NOTE In next step, be sure to minimize auxiliary lamp movement while tightening. If

Figure 8-56. Auxiliary Lamp Aiming

10. 11. b. c. 12. a. See lamp aim will be incorrect. b. c. d. 13.

Check headlamp alignment. Adjust if necessary. See
3 Adjust headlamp high beam for proper height and lateral alignment. Locate left side auxiliary lamp relative to high beam centerlines. Locate right side auxiliary lamp relative to high beam centerlines. Adjust high intensity beam below and right of left side auxiliary lamp centerlines. Adjust high intensity beam below and right of right side auxiliary lamp centerlines.

ADJUSTMENT: FLSTC/FLSTN

1.29 HEADLAMP ALIGNMENT. With a rider seated on the motorcycle and the front wheel pointed straight ahead, turn on the headlamp high See Figure 8-56. Mark the center of the headlamp high beam by making a vertical line through the horizontal line already drawn on the wall. Properly adjusted, the beam should project an equal area of light to the left and right of the vertical centerline (1). Turn the headlamp off and move to the front of the motor- Measure the distance from the headlamp horizontal cen- terline down to the horizontal centerline of the left side auxiliary lamp. Now measure the distance from the head- lamp vertical centerline o

MODELS beam. cycle. the same lamp. 3).

HOME 1. 2. 3. 4. 5. 6. 7. 8. 9. f2322x8x 1. 2. 3. 4. 5.