Page 1088 - 2006 HARLEY FLSTCI SERVICE MANUAL

8-49

6
2006 Softail: Electrical
7

8
5

4 Figure 8-62. Front Turn Signals: FLSTS, FXSTS

Set screw Ball stud Turn signal bracket Jam nut Turn signal Socket Lens Bulb

s0597x8x 3 2 1 1. 2. 3. 4. 5. 6. 7. 8.

(5.7-7.9 in-lbs
Follow preliminary steps listed under LAMP REPLACE-

Front Turn Signals: FLSTSC, FXSTS

NOTE Before removing turn signal wires, carefully note routing. In particular, pay close attention to the locations of cable straps Remove fuel tank fasteners and slide tank back to reveal front turn signal connector [31]. See 4.7 FUEL TANK: CARBURETED or 9.5 FUEL TANK: EFI. Disconnect [31] Detach front turn signals from mounting point. a. See Figure 8-62. Remove set screw (1) from turn Use a ball Allen wrench to remove ball stud (2) from turn signal (5) and turn signal bracket. Install ball stud through signal bracket from inboard Thread on jam nut all the way onto ball stud. Thread ball stud into turn signal. Finger tighten jam nut ag

MENT, GENERAL. which must be replaced. and remove terminals. signal bracket (3). Loosen jam nut (4). Install new front turn signal. side. Nm). pletely removed, replace. REPLACEMENT, GENERAL.

HOME 1. 2. 3. b. c. 4. a. b. c. d. e. f. g. 5. 6.