Page 1087 - 2006 HARLEY FLSTCI SERVICE MANUAL

s0558x8x

Mounting clamp 1 2 6

Screw Screw 3 1

4. 5. 6. 4 Figure 8-60. Front Turn Signals: FXSTB 3 2 Retainer and washer (right side only) Figure 8-61. Front Turn Signals: FXST, FXSTD, FLSTF, FLST

Turn signal Jam nut Standoff 5 4 Turn signal Jam nut Ball stud Ball stud clamp Nut (left side only)

6 5 s0557x8x
1. 2. 3. 1. 2. 3. 4. 5. 6.

Follow preliminary steps listed under LAMP REPLACE-
Front Turn Signals: All But FLSTC, FLSTN,

NOTE Before removing turn signal wires, carefully note routing. In particular, pay close attention to the locations of cable straps Remove fuel tank fasteners and slide tank back to reveal front turn signal connector [31]. See 4.7 FUEL TANK: CARBURETED or 9.5 FUEL TANK: EFI. Disconnect [31] Detach front turn signals from mounting point. For FXSTB models, see Figure 8-60. Remove two screws (4) from each mounting clamp. Hold jam nut (2) and remove screw (5) to detach turn signal. For all models except FXSTB see Figure 8-61. On right side, hold retainer (6) and loosen ball stud clamp (4) to remove turn signal. On left side, remove nut (5)

FLSTSC, FXSTS MENT, GENERAL. which must be replaced. and remove terminals. nal connectors. Install new front turn signal. model being serviced. REPLACEMENT, GENERAL. 2006 Softail: Electrical

HOME 1. 2. 3. a. b. c. 4. a. b. c. 5. 6. 8-48