Page 1086 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.25 8-47

Figure 8-58. Lens Cap Removal Figure 8-59. Front Turn Signal Connector [31] 2006 Softail: Electrical

o0158coxb 10115
TURN SIGNALS/RUNNING LIGHTS

See Figure 8-58. Insert coin in notch. Carefully twist coin
Signals: Rear Turn
BULB REPLACEMENT: ALL BUT
Locate notch on front or rear turn signal lens cap.
until lens cap pops out of turn signal housing.
Push bulb in and turn counterclockwise. Pull bulb from socket when tab on bulb clears open- new light bulb in and turn clockwise to lock in Snap lens cap back into turn signal housing. BULB REPLACEMENT: FLST/FLSTC To change a bulb, remove the lens, turn the bulb 1/4 turn while pressing the bulb into the housing, and remove the bulb. Replace the bulb and install the lens. NOTE If after replacing a bulb, the turn signal or running lamp will not light, check the wiring, the ground at the socket and/or the NOTE See 8.23 AUXILIARY LAMPS: FLSTC/FLSTN for front turn signal replacement on FLSTC and FLSTN models. For all other

FLST/FLSTC Replace bulb. ing on socket. Push place. LAMP REPLACEMENT FXSTD.

HOME 1. 2. 3. a. b. c. 4. switch. General To 1. 2. 3. 4.