Page 1274 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.8 8-17

NOTE If spoiler/regulator bracket must be removed, refer to 8.9 See Figure 8-15. Install ground wire (4) on bracket fas- tener (3) and tighten bracket fastener to 70-100 in-lbs Connect regulator-side pin connector [46A] to stator-side Install regulator. Apply LOCTITE THREADLOCKER 243 (blue) and tighten fasteners (5) to 50-80 in-lbs (6-9 Nm). Route single regulator wire (6) along side frame rails to Connect single wire to main circuit breaker silver stud. See MAIN CIRCUIT BREAKER in Softail Models Service Install inner rear fender. See ELECTRICAL PANEL in the Install cable straps to single wire connecting main circuit breaker to regulator a

Remove regulator. SPOILER/REGULATOR BRACKET. INSTALLATION (8-11 Nm). socket connector [46B]. main circuit breaker. Manual. Softail Models Service Manual. (7-10 Nm). or serious injury. (00070a) Replace seat.

10. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.

3
4 6

11WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) Remove inner rear fender. See ELECTRICAL PANEL in Remove nuts and wires from silver stud on main circuit breaker. See MAIN CIRCUIT BREAKER in Softail Mod- Follow and note routing of single black wire from main circuit breaker forward to regulator. Cut cable wraps as See 2.8 FRONT SPOILER. Follow procedure to remove See Figure 8-15. Unplug regulator to stator connector (1) Remove bolt (3) attaching regulator ground wire (4). 5 2 7 Stator to regulator connector [46] Wire retainer strap, Part No. 10177 Figure 8

REGULATOR Remove seat. battery cable before proceeding. (00048a). Disconnect negative battery cable. the Softail Models Service Manual. els Service Manual. necessary to free black wire. front spoiler. [46]. Remove or cut wire strap (2). Remove regulator bolts (5). 1 Bracket retaining bolt Ground wire Regulator bolts (2) Black wire (regulator output) Conduit

HOME REMOVAL 1. To 2. 3. 4. 5. 6. 7. 8. 9. 10931 1. 2. 3. 4. 5. 6. 7.