Page 708 - 2006 HARLEY FLSTCI SERVICE MANUAL

1.7 BLEEDING 2-59

4
Figure 2-74. Springer Brake Bracket 11WARNING 1WARNING After repairing the brake system, test brakes at low speed. If brakes are not operating properly, testing at high speeds can cause loss of control, which could

3 Turn ignition switch ON. Pump brake hand lever to Test ride the motorcycle. If the brakes feel spongy, 2006 Softail: Chassis

2 result in death or serious injury. (00289a) verify operation of the brake lamp. bleed the system again. See
Brake bracket Mounting plate Test brake system. BRAKES.

1 Cast-in nub Hole
s0373x2x 1. 2. 3. 4. 15. a. b.

Insert the lower mounting bolt (6) through the caliper (5)
new Tighten

and the bracket hole. See Figure 2-74. Thread lower mounting bolt into the tapped hole at the lower end of mounting plate. Tighten to 25-30 ft-lbs (33.9-40.7 Nm). See Figure 2-73. Tighten the upper mounting bolt (7) to 25-30 ft-lbs (33.9-40.7 Nm). Install washer and spring pin (9). Install bleeder valve (4) into the caliper, if removed. Tighten to 80-100 in-lbs (9.0-11.3 Nm). CAUTION Avoid leakage. Be sure gaskets, banjo bolt(s), brake line and master cylinder bore are clean and undamaged before assembly. (00322a) Install the brake line (1), if removed. The brake line is installed from the left side of the front fork. Lubricate new banjo washe

HOME 6. 7. 8. 9. 10. 11. 12. 13. 14.