Page 711 - 2006 HARLEY FLSTCI SERVICE MANUAL

Figure 2-77. Springer Brake Bracket 1CAUTION Direct contact of D.O.T. 4 brake fluid with eyes can cause irritation. Avoid eye contact. In case of eye contact flush with large amounts of water and get medical attention. Swallowing large amounts of D.O.T. 4 brake fluid can cause digestive discomfort. If swallowed, obtain medical attention. Use in well ventilated area. KEEP OUT OF

4
3 Add D.O.T. 4 BRAKE FLUID to the master cylinder reser- voir until the fluid level is 1/8 inch (3.2 mm) from the top. Do not reuse old brake fluid. Use only D.O.T. 4 fluid from

Brake bracket Cast-in nub Mounting plate REACH OF CHILDREN. (00240a) a sealed container.
2

1 Hole
s0373x2x 1. 2. 3. 4. 11.

Coat the outside diameter of lower mounting bolt (15) with Dow Corning MOLY 44 light Position the caliper with the disc between the friction pads. Align the two mounting holes in the caliper with the Place flat washer (13) on upper mounting bolt (12), then insert the bolt through the bracket holes and the mount- ing plate. Screw the bolt into the threaded bushing. NOTE See Figure 2-77. The Springer brake bracket has a cast-in Insert the lower mounting bolt (15) through the caliper and the bracket hole. Thread it into the tapped hole at the lower end of mounting plate. Tighten lower mounting bolt to 25-30 ft-lbs (33.9-40.7 Tighten upper mountin

INSTALLATION Figure 2-76. grease (Part No. 94674-99). mounting holes in the bracket. nub that engages a hole in the mounting plate. Figure 2-76. to 80-100 in-lbs (9.0-11.3 Nm) bracket and install screw (11). cotter pin (4). (13.6-27.1 Nm). Install new cotter pin (3). before assembly. (00322a) clamp bolt. 2006 Softail: Chassis

HOME See 1. 2. 3. See 4. Nm). 5. 6. 7. 8. 9. 10. 2-62